Online Programming

1.First connect the micro:bit to the computer with the data cable. At this time, the computer will have a micro:bit U disk. Open the USB flash drive and click on the micro:bit URL as shown in Figure1_1 below to enter the micro:bit official website. You can enter this web address directly in your browser:

http://microbit.org

Figure1-1

2.After successfully entering the URL,you will see page as Figure1-2 below

Figure1-2

3.Click [Let's code] at the top of the interface shown in Figure 1-3. At this point we will enter a new interface.

Figure1-3

4. After entering a new page, click [Go to Makecode editor] at the bottom of the interface shown in Figure

1-4 below, and you will be able to enter the MakeCode editor.

Figure1-4

5.After clicking, we will enter the interface shown in Figure1-

5 below. We need to click [New Project] in the lower left corner to enter the MakeCode editor.

Figure1-5

6. The interface shown in Figure1- 6 below is the micro:bit online programming interface we need to use.